Instructions for steps and instructions for lean-to ladders you will find many other products according to DIN EN 14183 and DIN EN 131-2/131-3 in the online shop of the brewes GmbH. inspection and maintenance of ladders and kicks by the frequent use and transporting ladders and kicks are regular checks regarding the security necessary, fast wear and tear may occur. The inspection intervals are based on, how often, how much and where the device is usually used. In addition, test results and any detected defects from previous checks are included. An organized approach to testing should begin with the numbering of the ladders and steps. Boy Scouts may find this interesting as well. Each device is maintained on the basis of a checklist. The individual data sheets can be worn together for a better overview in a check book. The following points should be handled on the Checklist: wear, deformation or destruction of components missing components of proper functioning of the connection elements after the completed test is, if necessary, repair.
Is it only a person with sufficient technical knowledge can carry out repairs to minor defects. These include inter alia replacing or the installation of conductor feet, cut the head in case of damage the ends of the handle or the replacement of screw sprouts. This exceeds one or other necessary repair work the skills of the craftsman, a competent person must be consulted. After each modification or maintenance work on ladders or kicks, the equipment must be inspected again on their safety there. After successful verification the appropriate test badge tested according to DIN EN 131-2 “attached. This is a specific field available on the instructions for use.